Electrical Connection - Champion MD-1000HT Installation Manual

The dishwasher must be electrically grounded according to all local codes and
regulations governing the installation of electrical service.
Disconnect the main electric supply and place a tag at the fuse or disconnect switch
indicating that work is being performed on that circuit.
1. Locate the control cabinet keys on the rear of the control cabinet.
2. Remove 1 key to unlock the cabinet; do not remove the other key.
3. Unlock the control cabinet and remove the cover.
4. Locate the power cable knock out and main terminal block on the left-side of the cabinet.
5. Locate the Machine Electrical Connection Data Plate mounted near the terminal block.
The MACHINE ELECTRICAL CONNECTION DATA PLATE
requirements. DO NOT use electrical data from any other sourceunless an authorized factory representative
6. Connect the electric service to the dishwasher.
ATTENTION
The Model VC-1000HT dishwasher
power switch located on the front of the top-mounted control cabinet
Start-up at the same time.

Electrical Connection (1000 Series HT)
Warning:
Warning:
instructs you to use other data.
Cable knock-out
Machine Electrical
Connection Data Plate
Main terminal block
must not be turned ON
Powering the dishwasher without performing the Initial Start-up
may damage the dishwasher's electrical circuits.
1000 Series HT - Installation Guide
Installation Guide
is the certified authority for the dishwasher power
ELECTRICIAN
at the dishwasher's
without performing an Initial
5