Table of Contents
Advertisement
1000 Series HT - Installation Guide
Installation Guide
Chemical Dispensers (1000 Series HT)
Continued from page 11
10. There are 8 Cams on the cycle timer. They
are numbered 1-8 starting at the timer
motor side of the assembly.
11. Look at the underside of the detergent and
the Rinse-aid timer microswitches and
identify the common terminals.
12. Connect the hot lead for the detergent
pump to the common terminal of Cam
Switch No. 5. Make the connection using a
12-14 slip-on terminal. Do the same for the
rinse-aid switch.
13. Now you must connect your pumps to
the dishwasher neutral return. All white
wires marked with No. 2 are neutral wires;
however, you are not authorized to connect
to any #2 wire that you may identify.
14. Run a 12 gauge white wire with spade
terminal connector (not supplied) from your
chemical dispensing pumps to the neutral
#2 white wire located on the main power
transformer in the control cabinet.
1
- Quick Links:
- Service Replacement Parts
Hide quick links:
Advertisement
Table of Contents
