Initial Start-Up - Champion MD-1000HT Installation Manual

POWER UP THE DISHWASHER:
As stated on page 15, the dishwasher power switch must not
be turned without reading the instructions below.:
WASH RINSE PRESSURE
60
40
psi
80
20
CHAMPION INDUSTRIES, INC.
NSF
WINSTON-SALEM, NC
MODEL W 100
0
USG
P/N 108391
13. Turn on the main power switch at the service disconnect switch.
14. Flip the dishwasher power switch UP to turn on the dishwasher.
15. Immediately, push the fill switch up and hold it in the up position
until the water flows out of the wash tank and into the lower scrap screen.
16. Release the fill switch.
17. Open the dishwasher door fully and check the water level inside the tank.
The proper water level is just below the overflow tube and 3" [76 mm]
from the lower sprayarm support. Measure from the back of the support up the tank toward
the rear wall of the dishwasher.

" [mm]
FILL
CYCLE
DRAIN
Water line
1000 Series HT - Installation Guide
Installation Guide

Initial Start-up (1000 Series HT)
POWER
ON
OFF

10
1