Champion MD-1000HT Installation Manual page 22

1000 Series HT - Installation Guide
Installation Guide

C hemical Dispensers (1000 Series HT)
Priming the chemical dispensers
1. Factory dispensers are optional
equipment;however, an automatic dispenser
mustbe installed by someone in lieu of the
factory.
2. The dispensers are mounted on the right-hand
side of the lower wash tank.
3. Chemical pick-up tubes are inserted into their
respective containers.
4. Detergent and Rinse-aid chemical containers
can be placed a maximum of 11" [280 mm]
above the finished floor, (ABF).
5. Place the chemical containers as close to the dishwasher
as possible.
6. Each day check the detergent and rinse-aid chemical
containers to make sure they
are at least 1/2 full.
7. Push and hold the 2-position prime switch located on
the front of the top-mounted control cabinet. Push UP
to prime the detergent and DOWN to prime the rinse-
aid.
8. Watch the chemical as it travels up the tube to the
injection point sight-glass located on the right-hand side,
top-rear corner of the machine.
9. Release the switch when the chemical enters the sight-
glass.
10. Chemicals should reach the sight-glass within 2 minutes
of prime.A problem may exist if it takes longer than 3
minutes.
14
(Factory dispensers only)