Champion MD-1000HT Installation Manual page 43

POWER UP THE DISHWASHER:
1. Flip the dishwasher power switch UP to turn on.
2. Turn on the main power switch at the service disconnect switch.
3. Release the fill switch.
4. Open the dishwasher door fully and check the water level inside the tank.
The proper water level is just below the overflow tube and 3" [76 mm]
from the lower manifold measuring up the tank toward the rear of the
dishwasher.
3"
[76mm]
6. To drain the dishwasher, leave the machine power
switch in the ON position.
Doors are fully closed.
7. Push and hold the "FILL/DRAIN" switch down
in the "DRAIN" position for approximately 15-20
seconds.
8. The water in the wash tank will drain completely.
9. Open the doors and check that all water has
drained for the machine.
10. The initial start-up is complete.

5. Operate the dishwasher for 10 cycles
checking the temperature gauges to
ensure the machine is maintaining
140° F/60° C minimum wash temperature
Water line
140° F/60° C minimum final rinse temperature
1000 Series LT - Installation Guide
Installation Guide
Initial Start-Up (1000 Series LT)
the proper temperatures.
35