Table of Contents
Advertisement
1000 Series LT - Installation Guide
Installation Guide
Unpack and Place (1000 Series LT)
1. Compare the dishwasher and site utility connections.
2. Level the dishwasher by adjusting the bullet feet.
3. Raise the doors and check the door clearance to the ceiling.
4. Move the dishwasher to its permanent location.
Installers must follow applicable sanitation, safety, plumbing, and electrical codes and
regulations; and work in accordance with best practices for dishwasher installation.
Utility Connections - 1000 Series LT
Power:
Water supply:
Drain:
Chemicals:
Chemical Dispensing Pumps - Factory Installed -1000 Series LT
•
All pumps use liquid chemicals
•
Detergent pump capacity =
Factory setting for detergent =
•
Sanitizer pump capacity =
Factory setting for Sanitizer=
•
Rinse-aid pump capacity =
Factory setting for rinse-aid
28
115VAC 15Amp circuit
3/4" NPT hot water supply (140°F/60°C minimum)
(35 psi/241 KPa static pressure) 7-10 psi/48-69Kpa flow pressure
1-7/8" stainless steel, slip-fit hose connection
Max flow: 15 Us gal/min. (13.5 Imperial gal/min) 57liters/min.
Detergent, rinse-aid, and sanitzer pumps are standard equipment.
Chemicals supplied by a chemical supplier
Note:
165ml / min @ 108 RPM
10 sec. / 28ml
35cc/min @ 14RPM
14cc in 23 sec.
maintains 50PPM concentration of
5.25% sodium hypochlorite during
the final rinse cycle.
21 ml / min @ 14RPM
10 sec. / 3.5 ml
- Quick Links:
- Service Replacement Parts
Hide quick links:
Advertisement
Table of Contents
