1000 Series HT - Installation Guide
Installation Guide
Chemical Dispensers (1000 Series HT)
Continued from page 9
115VAC Power Connections for Chemical Dispensers
FOR QUALIFIED INSTALLERS ONLY
Chemical dispensers must be electrically grounded in compliance with applicable electric codes.
Disconnect the main electric supply and place a tag at the fuse or disconnect switch indicating that
Connecting chemical dispensers at points other than those recommended by the factory may
1. Unlock the top-mounted control cabinet with the key. two keys should be stowed behind the
control cabinet. The installing electrician used one key during their installlation.
2. Locate the cycle timer mounted in the right-rear corner of the control cabinet.
3. Refer to the 1000 Series HT electrical schematic located at the end of this manual.
4. Find the following components shown on the electrical schematic at end of this manual.
10
Warning:
Warning:
work is being performed on that circuit.
Caution:
damage the dishwasher electrical system.
.