Selecting Other Facilities; Setup; Print Setup; Testfeed - Intermec EasyCoder PM4i User Manual

Selecting Other Facilities

EasyCoder PM4i Printer User's Guide (Fingerprint Version)
Chapter 8 — Intermec Shell Startup Program
Note:
When an application program is started, it may
automatically change the communication setup. If another
application is selected later, this communication setup will remain
valid, unless the new application includes instructions that
automatically change the setup. The setup could also be changed
manually in the Setup Mode.
As an alternative to selecting an application, you can step through
a number of other useful facilities:

Setup

Set up the printer using its built-in keyboard, see Chapter 7,
"Setup Mode."

Print Setup

Produce a printout of the printer's current setup values (test label
"Setup Info").

Testfeed

Feed out a number of label, ticket, tag, or portions of continuous
stockwhile the printer auto-adjusts its media feed and label stop/
black marksensor. It is recommended to perform a Testfeed each
time you load a roll of labels from a new batch or a different
brand.

Test Label

Print a series of four test labels (test labels "Diamonds", "Chess",
"Bar Codes #1", and Bar Codes #2") in order to test the printout
quality and printhead alignment. The labels are presented in an
infi nite loop, so you can print the series over and over again.
Press <Enter> for each new label.

Default Setup

Reset all setup parameters to their default values, as listed in
Chapter 6, "Setting Up the Printer."

Software Update

Using the Zmodem communication tool, files can be
downloaded from a PC, either to be stored on a standard
CompactFlash memory card or to upgrade the printer's firmware.
The following options are available:
77