Intermec EasyCoder PM4i User Manual page 88

Chapter 7 — Setup Mode
72
The Setup Mode is organized as an endless loop, from which you
can select a number of sub-categories. At startup, the firmware
determines if options such as a label taken sensor, a cutter, or an
interface board is installed in the printer. Only installed options
are shown in the Setup Mode.
The diagram below shows the options in the main loop. Detailed
overviews are shown on the pages that follow.
SETUP:
SER-COM, UART1
SETUP:
PRINT DEFS
SETUP:
MEDIA
SETUP:
FEEDADJ
Legend:
Dotted boxes and lines indicate options.
Thick boxes indicates default options.
Values inside brackets indicate default settings.
EasyCoder PM4i Printer User's Guide (Fingerprint Version)
Starting point
SETUP:
SER-COM, UART2
SETUP:
NET-COM, NET1
SETUP:
NETWORK
Option
Option
SETUP:
SER-COM, UART3
Option
SETUP:
SER-COM, UART4
Option
SETUP:
SER-COM, UART5
Option
Option