Integral Liner Takeup Unit; Paper Cutter; Media Supply Hub; Paper Sensor - Intermec EasyCoder PM4i User Manual

Integral Liner Takeup Unit

Paper Cutter

Media Supply Hub

Paper Sensor

Tear-Off Bar

Media Roll Retainer

EasyCoder PM4i Printer User's Guide (Fingerprint Version)
The integral liner takeup unit is an optional device for peel-off
(self-strip) operation, which means that the labels are separated
from a liner (backing paper) after printing and the liner is wound
up on an internal hub. The unit also includes a guide shaft. Peel-
off cannot be combined with an internal fanfold guide. For more
information, see Chapter 4, "Media Load."
The paper cutter is designed to cut off continuous paper-based
stock or liner between labels. The cut-off labels, tickets, or tags
can be collected on an optional tray.The paper cutter can be
controlled using the instructions CUT, CUT ON, and CUT
OFF in Intermec Fingerprint and the Direct Protocol. For more
information, see Chapter 4, "Media Load."
The rotating media supply hub is designed to fit media roll cores
with an internal diameter of 38-40 mm (1.5 in).
The paper sensor is fitted inside a plastic cover in the center
section below the media supply hub. It can only be used with a
rotating media supply hub and detects when the remaining
media supply has reached a preset minimum diameter, as
specified in the Setup Mode.
The adjustable tear-off bar is particularly useful when delicate
media is used in peel-off operation.
The retainer is intended to keep large media rolls in place when
using a rotating media supply hub. It restricts the maximum
media width to 100 mm (3.9 in). Installed by the operator.
Chapter 9 — Options
85