Tickets With Black Mark - Intermec EasyCoder PM4i User Manual

Appendix B — Media Specifications

Tickets With Black Mark

136
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 11.
⇐ d ⇒ Detection Slit Length
The length of the detection slit (excluding corner radii) must be
minimum 2.5 mm (0.10 in) on either side of the LSS detection
position (e).
⇐ e ⇒ Detection Slit Height
Maximum:
Recommended:
Minimum:
Media Type Setup
• Ticket (w gaps)
Note: Do not allow any perforation to break the edge of the
media as this may cause the media to split and jam the printer.
⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Minimum:
Maximum:
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 11.
⇐ d ⇒ Black Mark Width
The detectable width of the black mark should be at least 5.0 mm
(0.2 in) on either side of the LSS detection point.
⇐ e ⇒ Black Mark Length
Maximum:
EasyCoder PM4i Printer User's Guide (Fingerprint Version)
21.3 mm (0.83 in)
1.6 mm (0.06 in)
1.2 mm (0.05 in)
114.3 mm (4.50 in)
25.0 mm (1.00 in)
20.0 mm (0.8 in)
depends on SDRAM size
21.3 mm (0.83 in)