Media; Media With Rfid Tags/Inlays; Non-Adhesive Strip - Intermec EasyCoder PM4i User Manual

Media

Media with RFID Tags/Inlays

Non-Adhesive Strip

EasyCoder PM4i Printer User's Guide (Fingerprint Version)
The maximum recommended media thickness is 175
with the standard printhead or 220
printhead. Thicker media may be used, but print quality will be
reduced. The stiffness is also important and must be balanced
against thickness to maintain print quality.
Media rolls to be loaded inside the printer should be wound with
the printable side facing outwards.
The media supply must not be exposed to dust, sand, grit, etc.
Any hard particles, however small, can damage the printhead.
When printing on RFID media, special consideration must be
taken to the position and shape of the tag. Specific
recommendations for different kinds of Intermec-approved
RFID media can be found on the Intermec website. Additional
information is provided in the documentation that came with
your RFID kit.
⇐ a ⇒ Media Width
Maximum:
Minimum:
Media Type Setup
• Fix length strip
• Var length strip
Appendix B — Media Specifications
μ
m (8.7 mils) with a special
114.3 mm (4.50 in)
25.0 mm (1.00 in)
μ
m (7 mils)
131