Returning To Factory Default Setup - Intermec EasyCoder PM4i User Manual

Chapter 6 — Setting Up the Printer

Returning to Factory Default Setup

68
There are two ways to return to the factory default setup of the
printer:
A Insert a special CompactFlash memory card and restart the
printer.
B Using the printer's built-in keyboard.
To reset the printer using the keyboard:
1 Lift the printhead.
2 Switch on the power to the printer and press the i key and
wait until the printer beeps.
3 Swiftly press the following keys:
/Esc
4 The following message will be displayed:
Factory Default?
Enter=Yes ESC=No
5 Within 10 seconds, press Enter to reset the printer to factory
default. The parameters will be reset and the printer will
continue the normal startup.
If you press /Esc or wait until the 10 seconds timeout has
passed, the normal startup will continue without any reset
being performed.
Note: If any of the files "card:NOSHELL.CFG",
"rom:NOSHELL.CFG", or "c:NOSHELL.CFG" exists in the
printer's memory, no reset to factory default will be performed.
The factory default will remove all files used to store settings. It
will not reset settings that already has been read when the files are
removed. This means that EasyLAN Wireless settings (SSID,
keys, etc.) will retain their values from the previous start.
However, the next reboot will reset them to factory default.
EasyCoder PM4i Printer User's Guide (Fingerprint Version)
/Esc