Setting Up The Printer Description - Intermec easycoder f2 Installation & Operation Manual

Chapter 6
Setting Up the Printer
Description
40
The setup is used to control the printer in regard of serial com-
munication, paper feed and print speed, and to specify which type
of paper is loaded in the printer.
Check the list of default setup values below to see if the printer's
setup matches your requirements. If not, you will have to change
the setup, which can be done manually via the printer's built-in
keyboard, remotely from the host computer, or by reading a bar
code containing setup data with the optional EasySet bar code
wand. The setup may also be changed, partially or completely, by
certain application programs.
• In the Setup Mode:
- Press the < Setup> key on the printer's built-in keyboard
to enter the Setup Mode.
- Select the Setup option in Intermec Shell to enter the
Setup Mode.
- Execute the Intermec Fingerprint SETUP instruction to
enter the Setup Mode.
See chapter 7 "Setup Mode" in this manual.
• In Intermec Shell:
- Use Terminal Setup option to change the setup remotely
from the host.
Note that Intermec Shell automatically sets up the printer in regard
of communication when an application is selected.
See chapter 8 "Intermec Shell" in this manual.
• In Intermec Fingerprint:
- Use Setup strings to change individual setup parameters
remotely from the host.
- Use Setup fi les to create sets of setup parameters remotely
from the host.
See SETUP statement in the Intermec Fingerprint 7.xx Reference
Manual.
• In the Intermec Direct Protocol:
- Use Setup strings to change individual setup parameters
remotely from the host.
See Intermec Direct Protocol 7.xx Programmer's Guide.
• Using the EasySet Bar Code Wand:
- Read a Code 128 bar code containing the setup parameter id.
and the desired value or choice. See Appendix 4.
Intermec EasyCoder F2 – Installation & Operation Ed. 2