I Programmed Scan Operation; I Memory Scan Operation - Icom IC-703 Instruction Manual

I Programmed scan operation

q Select VFO mode.
w Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e Set [SQL] open or closed.
• See page a left for squelch condition.
r Select
.
• Push [DISPLAY] once or twice to select .
• Push [MENU] one or more times to select
t Push [
] to start the scan.
(F-1)
• Decimal point blinks while scanning.
y When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
• During scan [TS] can be used only when resume is ON.
u To cancel the scan push [
NOTE: If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.

I Memory scan operation

q Select memory mode.
w Close the squelch with [SQL].
e Select
.
• Push [DISPLAY] once or twice to select .
• Push [MENU] one or more times to select
r Push [
] to start the scan.
(F-1)
• Decimal point blinks while scanning.
t When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
y To cancel the scan push [
NOTE: Two or more memory channels must be
programmed for memory scan to start.
.
].
(F-1)
.
].
(F-1)
SCAN OPERATION
[F-1]
[SQL] [MANU] [DISPLAY]
USB
VFO A
S1
3 5 7 9 20 40 60dB
P 5
O 10
F-1
then push [
[F-1]
[SQL] [MANU] [DISPLAY]
USB
S1 3 5 7 9 20 40 60dB
MEMO
P 5 10
O
F-1
then push [
8
Select
VFO mode
CH
]
(F-1)
Select
memory mode
CH
]
(F-1)
62
8