Connect Other Peripheral Equipment; I Operation; Voice - Icom IC-703 Instruction Manual

QUICK REFERENCE GUIDE

5. Connect other peripheral equipment

Everyone has his or her favorite ad-on gear; now is
the time to connect this gear! We will cover the basic
devices that can be connected to your IC-703.

I Operation

1. Voice

Microphones: Connect the microphone to the modu-
lar-type connector bottom of the front panel or back
of the radio.
Rear panel
2. CW
CW Key: There are several types of keys or keyers
that can be used with your IC-703.
a. Iambic Key paddle: Use a 6.35(d) mm (
plug and connect to the [KEY] jack located on the
rear of the radio.
Rear panel
CW KEY
When connecting a paddle
III
If you do not see the particular item you are wanting
to connect, refer to the Advance Connections section
starting on page 14.
b. Straight Key: Use a 6.35(d) mm (
c. External Keyer: Use a 6.35(d) mm (
") stereo
1 ⁄
4
d. Computer Keying: Use a 6.35(d) mm (
(dot)
(com)
(dash)
Front panel
MICROPHONES
HM-103
and connect key to the back of the radio.
plug and connect to the back of the radio.
plug and connect to the back of the radio.
Rear panel
CW KEY
A straight key can be used when the internal
electronic keyer is turned OFF in keyer set
mode. (p. 32)
When connecting a straight key or else
NOTE: You will need to select the type of keyer you
are using in the keyer set mode. There are many
advanced CW functions in this set mode. Until you
have a full understanding of these functions
change only the items necessary.
SM-20 OPC-589
") mono plug
1
⁄
4
") mono
1 ⁄
4
") mono
1 ⁄
4
(+)
(_)