I Select Memory Scan Operation; I Priority Watch - Icom IC-703 Instruction Manual

8
SCAN OPERATION

I Select memory scan operation

q Select memory mode.
w Close the squelch with [SQL].
e Select
.
• Push [DISPLAY] once or twice to select .
• Push [MENU] one or more times to select
r Push [
] to start the memory scan.
(F-1)
• Decimal point blinks while scanning.
t Push [
] to change the memory scan to se-
(F-2)
lect memory scan.
• Push [ ] for 2 sec. to clear all select memory
(F-2)
channels.
y When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u To cancel the scan push [
NOTE: Two or more memory channels must be
designated as select memory channels for select
memory scan to start (see p. 61).

I Priority watch

q Select VFO mode, then set a frequency.
w Close the squelch with [SQL].
e Set the desired memory channel as the watching
channel.
r Select
.
• Push [DISPLAY] once or twice to select .
• Push [MENU] one or more times to select
t Push [
] to start the priority watch.
(F-2)
• Decimal point blinks while scanning.
y When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.
u To cancel the scan push [
NOTE: The paused condition when detecting a sig-
nal differs depending on the scan resume condi-
tion. (p 80)
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.
63
.
].
(F-1)
.
].
(F-2)
[F-1]
[SQL] [MANU] [F-2] [DISPLAY]
USB
S1
3 5 7 9 20 40 60dB
MEMO
P 5
10
O
F-1 F-2
Push [ ], then [
(F-1)
[SQL] [MANU] [F-2] [DISPLAY]
USB
VFO A
S1 3 5 7 9 20 40 60dB
P 5 10
O
F-2
Push [
Select
memory mode
Designate
S
CH
"S."
].
(F-2)
Select
VFO mode
Select watching
CH
channel
].
(F-2)