Confirmation Beeps; Band Edges Beeps; Beep Level Adjustment; Beep Audio Level Limit - Icom IC-703 Instruction Manual

12
SET MODE
(Confirmation beeps)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
*
A beep sounds when an operating frequency enters or
exits a transmit frequency range. This functions inde-
pendent of the confirmation beep setting (above).
When " " is set ON, this item adjust the con-
firmation beep level. Adjustable levels are 0 to 10 in 1
steps.
*
This item allows you to set a maximum volume level
for confirmation beep tones. Confirmation beep tones
are linked to the [AF] control until a specified volume
level is reached— further rotation of the [AF] control
will not increase the volume of the beep tones.
*
This item select the carrier point of CW mode from
LSB and USB.
This item sets the CW side tone output level. Selec-
table levels are 0 to10 in 1
*
This item sets the CW side tone level limit. When the
[AF] control is rotated above a specified level, the CW
side tone does not increase.
on : CW side tone level is limited. (default)
oFF : CW side tone level is not limited.
77
When "
(Band edges beep)

(Beep level adjustment)

(Beep audio level limit)

(CW carrier point setting)

(CW side tone level)

steps.

(CW side tone level limit)

" is set to ON, * marked items are undisplayed.
Confirmation beep ON
(default)
Band beep ON
(default)
The default is 5.
Beep limit ON
(default)
The carrier point is
LSB side (default).
The default is 5.
CW side tone limit ON
(default)
Confirmation beep OFF
Band beep OFF
Beep limit OFF
The carrier point is
USB side.
CW side tone limit OFF