172: Insert cleaning card
1.
Insert cleaning card.
2.
If the card is not immediately picked, press the printer's U
Click Cancel if you want to cancel the cleaning card.
173: Improper shutdown
Always use the P
Press and hold the U
Click OK to clear the message.
Laminator Messages
The following messages display on the printer LCD panel when you are using an SD460 laminating
system. They also display in a message on the PC that issued the card print job.
177: Laminator not available
The printer and laminator cannot communicate. The card will be canceled.
1.
Make sure the data cable from the laminator to the printer is securely plugged in.
2.
Press the printer P
3.
Press the P
196: Laminator error critical
The laminator has encountered a critical error. The card will be canceled.
1.
Press the printer P
2.
Request service. The system must remain powered off.
197: Laminator entry card problem
The card is not where it should be in the laminator.
1.
Open the laminator.
2.
Turn the knob to remove the card.
3.
Close the laminator.
68
button to power off the printer.
OWER
button to set the printer to Ready.
SER
button to power off the system.
OWER
button again to power on the system.
OWER
button to power off the system.
OWER
button or click OK.
SER
Troubleshooting