Configurable Vlan Parameters; Vlan Default Configuration - Cisco WS-C2950SX-48-SI Configuration Manual

VLAN Default Configuration

Configurable VLAN Parameters

Whenever you create or modify VLANs 2–1005, you can set the parameters as follows:
Note Ethernet VLANs 1 and 1025–4094 can use the defaults only.
With VTP version 3, you can manage extended-range VLANs 1025–4094. These VLANs are propagated
Note
with VTP version 3.
With software release 8.1(1), you can name extended-range VLANs. This capability is independent of
Note
any VTP version or mode.
•
•
•
•
•
•
•
•
•
•
Ethernet VLANs 1 and 1025–4094 can use the defaults only.
Note
VLAN Default Configuration
Table 10-2
Table 10-2 VLAN Default Configuration
Feature
Native (default) VLAN
Port VLAN assignments
VLAN state
MTU size
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
10-4
VLAN number
VLAN name
VLAN type: Ethernet, FDDI, and FDDINET
VLAN state: active or suspended
Multi-Instance Spanning Tree Protocol (MISTP) instance
Private VLAN type: primary, isolated, community, two-way community, or none
SAID
MTU for the VLAN
VLAN to use when translating from one VLAN media type to another (VLANs 1–1005 only);
requires a different VLAN number for each media type
Remote Switched Port Analyzer (RSPAN)
shows the default VLAN configuration.
Default Value
VLAN 1
All ports assigned to VLAN 1
Enabled
1500 bytes
Chapter 10 Configuring VLANs
—
Release 8.1
78-15486-01