Cisco WS-C2950SX-48-SI Configuration Manual page 498

Accounting Example
Figure 30-5 Example of a TACACS+ Network Topology
TACACS+
server
172.20.52.10
Workstation A
This example shows that TACACS+ accounting is enabled for connection, EXEC, system, and all
command accounting:
Console> (enable) set accounting connect enable stop-only tacacs+
Accounting set to enable for connect events in stop-only mode.
Console> (enable) set accounting exec enable stop-only tacacs+
Accounting set to enable for exec events in stop-only mode.
Console> (enable) set accounting commands enable all stop-only tacacs+
Accounting set to enable for commands-all events in stop-only mode.
Console> (enable) set accounting update periodic 120
Accounting updates will be periodic at 120 minute intervals.
Console> (enable) show accounting
Event
-----
exec:
connect:
system:
commands:
config:
all:
TACACS+ Suppress for no username: enabled
Update Frequency: periodic, Interval = 120
Accounting information:
-----------------------
Active Accounted actions on tty0, User (null) Priv 0
Active Accounted actions on tty288091924, User (null) Priv 0
Overall Accounting Traffic:
Exec
Connect
Command
System
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
30-54
Switch
Console port
connection
Terminal
Method Mode
------- ----
tacacs+ stop-only
tacacs+ stop-only
tacacs+ stop-only
- -
tacacs+ stop-only
Starts Stops Active
----- ----- ------
0 0 0
0 0 0
0 0 0
1 0 0
Chapter 30 Configuring Switch Access Using AAA
—
Release 8.1
78-15486-01