Displaying Gvrp Statistics - Cisco WS-C2950SX-48-SI Configuration Manual

Chapter 13 Configuring GVRP
Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently
Caution
on Layer 2-connected devices, GARP applications (for example, GMRP and GVRP) do not operate
successfully.
To adjust the GARP timer values, perform this task in privileged mode:
Task
Step 1
Set the GARP timer values.
Step 2 Verify the configuration.
This example shows how to set GARP timers and verify the configuration:
Console> (enable) set garp timer leaveall 10000
GMRP/GARP leaveAll timer value is set to 10000 milliseconds.
Console> (enable) set garp timer leave 600
GMRP/GARP leave timer value is set to 600 milliseconds.
Console> (enable) set garp timer join 200
GMRP/GARP join timer value is set to 200 milliseconds.
Console> (enable) show garp timer
Timer
--------
Join
Leave
LeaveAll
Console> (enable)

Displaying GVRP Statistics

To display GVRP statistics on the switch, perform this task:
Task
Display GVRP statistics.
This example shows how to display GVRP statistics for port 1/1:
Console> (enable) show gvrp statistics 1/1
Join Empty Received:
Join In Received:
Empty Received:
LeaveIn Received:
Leave Empty Received:
Leave All Received:
Join Empty Transmitted:
Join In Transmitted:
Empty Transmitted:
Leave In Transmitted:
Leave Empty Transmitted: 0
Leave All Transmitted:
VTP Message Received:
Console> (enable)
78-15486-01
Timer Value (milliseconds)
--------------------------
200
600
10000
0
0
0
0
0
40
156
0
0
0
41
0
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Command
set garp timer {join | leave | leaveall} timer_value
show garp timer
Command
show gvrp statistics [mod_num/port_num]
Configuring GVRP on the Switch
—
Release 8.1
13-7