Configuring Snmpv3 From An Nms; Configuring Snmpv3 From The Cli - Cisco WS-C2950SX-48-SI Configuration Manual

Configuring SNMPv3 from an NMS

Configuring SNMPv3 from an NMS
To configure SNMP from a Network Management System (NMS), refer to your NMS documentation
(also see the
The switch supports up to 20 trap receivers through the RMON2 trap destination table. Configure the
RMON2 trap destination table from the NMS.

Configuring SNMPv3 from the CLI

This section provides very basic SNMP v3 configuration information. For detailed information on the
Note
SNMP commands that are supported by the Catalyst enterprise LAN switches, refer to the
Catalyst 4500 Series, Catalyst 2948G, and Catalyst 2980G Switches Command Reference.
To configure SNMPv3 from the command-line interface (CLI), perform this task in privileged mode:
Task
Step 1
Set the SNMP-Server EngineID
name for the local SNMP engine.
Step 2
Configure the MIB views.
Step 3 Set the access rights for a group
with a certain security model in
different security levels.
Step 4
Specify the target addresses for
notifications.
Step 5 Set the snmpTargetAddrEntry in
the target address table.
Step 6
Set the SNMP parameters that are
used to generate a message to a
target.
Step 7
Configure a new user.
Step 8
Relate a user to a group using a
specified security model.
Step 9
Configure the community table for
the system default part, which maps
community strings of previous
versions of SNMP to SNMPv3.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
24-14
"Using CiscoWorks2000" section on page
Command
set snmp engineid engineid
set snmp view [-hex] {viewname} {subtree} [mask] [included |
excluded] [volatile | nonvolatile]
set snmp access [-hex] {groupname} {security-model v3}
{noauthentication | authentication | privacy} [read [-hex]
{readview}] [write [-hex] {writeview}] [notify [-hex]
{notifyview}] [context [-hex] {contextname} [exact | prefix]]
[volatile | nonvolatile]
set snmp notify [-hex] {notifyname} tag [-hex] {notifytag}
[trap | inform] [volatile | nonvolatile]
set snmp targetaddr [-hex] {addrname} param [-hex]
{paramsname} {ipaddr} [udpport {port}] [timeout {value}]
[retries {value}] [volatile | nonvolatile] [taglist {[-hex] tag}
[[-hex] tag]]
set snmp targetparams [-hex] {paramsname} user [-hex]
{username} {security-model v3} {message-processing v3}
{noauthentication | authentication | privacy} [volatile |
nonvolatile]
set snmp user [-hex] {username} [remote {engineid}]
[{authentication [md5 | sha] {authpassword}] [privacy
{privpassword}] [volatile | nonvolatile]
set snmp group [-hex] {groupname} user [-hex] {username}
{security-model v1 | v2 | v3} [volatile | nonvolatile]
set snmp community {access_type} [community_string]
(access_type = read-only | read-write | read-write-all)
Chapter 24
24-17).
—
Release 8.1
Configuring SNMP
78-15486-01