Cisco WS-C2950SX-48-SI Configuration Manual page 473

Chapter 30 Configuring Switch Access Using AAA
This example shows how to specify and enable the framed-IP address attribute by number:
Console> (enable) set radius attribute 8 include-in-access-req enable
Transmission of Framed-ip address in access-request packet is enabled.
Console> (enable) show radius
RADIUS Deadtime:
RADIUS Key:
RADIUS Retransmit:
RADIUS Timeout:
Framed-Ip Address Transmit:
RADIUS-Server
----------------------------- -------
10.6.140.230
Console> (enable)
This example shows how to specify and disable the framed-IP address attribute by name:
Console> (enable) set radius attribute framed-ip-address include-in-access-req disable
Transmission of Framed-ip address in access-request packet is disabled.
Console> (enable)
Clearing RADIUS Servers
To clear one or more RADIUS servers, perform this task in privileged mode:
Task
Step 1 Specify the IP address of the RADIUS server to
clear from the configuration. Enter the all
keyword to clear all of the servers from the
configuration.
Step 2
Verify the RADIUS server configuration.
This example shows how to clear a single RADIUS server from the configuration:
Console> (enable) clear radius server 172.20.52.3
172.20.52.3 cleared from radius server table.
Console> (enable)
This example shows how to clear all RADIUS servers from the configuration:
Console> (enable) clear radius server all
All radius servers cleared from radius server table.
Console> (enable)
Clearing the RADIUS Key
To clear the RADIUS key, perform this task in privileged mode:
Task
Step 1
Clear the RADIUS key.
Step 2
Verify the RADIUS configuration.
78-15486-01
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
0 minutes
123456
2
5 seconds
Enabled
Status Auth-port
------------
primary 1812
Command
clear radius server [ip_addr | all]
show radius
Command
clear radius key
show radius
Configuring Authentication
Acct-port
------------
1813
—
Release 8.1
30-29