Cisco WS-C2950SX-48-SI Configuration Manual page 306

Filtering IGMP Traffic
This example shows how to verify that an IGMP multicast filter profile 1 was deleted:
Console> (enable) show igmp filter profile 1
Console> (enable)
Listing or Removing All IGMP Multicast Filters
To list, remove, and verify all IGMP multicast filter profiles, perform this task in privileged mode:
Task
Step 1
Display all IGMP multicast filter profiles.
Step 2 Remove all IGMP multicast filter profiles.
Note When you remove a filter, all associations between the filter and associated ports are removed.
This example shows how to display all IGMP multicast filter profiles:
Console> (enable) show igmp filter all
ProfileId 1: FilterMode deny, IP Range
----------------------------------------------------
226.1.1.1
Console> (enable)
This example shows how to remove all IGMP multicast filter profiles:
Console> (enable) clear igmp filter all
Successfully remove all the profile(s)
Console> (enable)
This example shows how to verify that all IGMP multicast filter profiles were deleted:
Console> (enable) show igmp filter all
Console> (enable)
Assigning and Displaying Port Filter Associations
To assign and display IGMP multicast filter associations to a port or port list, perform this task in privileged
mode:
Task
Step 1
Assign IGMP multicast filters to a port or port list.
Step 2
Display all IGMP multicast port filter associations.
This example shows how to assign an association of module 2/port 1 to IGMP multicast filter profile 1:
Console> (enable) set igmp filter map 1 2/1
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
15-22
Chapter 15 Configuring Multicast Services
Command
show igmp filter all
clear igmp filter all
Command
set igmp filter map profile_id port_list
show igmp filter map {port_list | all}
—
Release 8.1
78-15486-01