Accounting Example - Cisco WS-C2950SX-48-SI Configuration Manual

Chapter 30 Configuring Switch Access Using AAA
Console> (enable) set accounting system disable
Accounting set to disable for system events.
Console> (enable)
Console> (enable) set accounting commands disable
Accounting set to disable for commands-all events.
Console> (enable)
This example shows how to disable suppression of unknown users:
Console> (enable) set accounting suppress null-username disable
Accounting will be not be suppressed for user with no username.
Console> (enable)
This example shows how to verify the configuration:
Console> (enable) show accounting
Event
-----
exec:
connect:
system:
commands:
config:
all:
TACACS+ Suppress for no username: disabled
Update Frequency: new-info
Accounting information:
-----------------------
Active Accounted actions on tty0, User (null) Priv 0
Active Accounted actions on tty288091924, User (null) Priv 0
Overall Accounting Traffic:
Exec
Connect
Command
System
Console> (enable)

Accounting Example

Figure 30-5
accountable event on the switch, the switch gathers event information and forwards the information to
the server at the conclusion of the event. Accounting information is gathered at the conclusion of the
event. Accounting is suspended for unknown users and the system is updated periodically every
120 minutes.
78-15486-01
Method Mode
------- ----
- -
- -
- -
- -
- -
Starts Stops Active
----- ----- ------
0 0
0 0
0 0
1 2
shows a simple network topology using TACACS+. When Workstation A initiates an
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
0
0
0
0
Accounting Example
—
Release 8.1
30-53