Configurable Normal-Range Vlan Parameters - Cisco Catalyst 4500 Series Software Configuration Manual

VLANs
Table 17-1
VLANs
1002–1005
1006–4094

Configurable Normal-Range VLAN Parameters

Ethernet VLANs 1 and 1006 through 4094 use only default values.
Note
You can configure the following parameters for VLANs 2 through 1001:
•
•
•
•
•
VLAN Default Configuration
Table
Table 17-2
Parameter
VLAN ID
VLAN name
802.10 SAID
MTU size
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
17-4
VLAN Ranges
Range Usage
Normal Cisco defaults for FDDI and Token Ring. You cannot delete
VLANs 1002–1005.
Extended For Ethernet VLANs only. When configuring extended-range
VLANs, note the following:
•
•
•
VLAN name
VLAN type
VLAN state (active or suspended)
SAID
STP type for VLANs
17-2 shows the default VLAN configuration values.
Ethernet VLAN Defaults and Ranges
Default
1
VLANx, where x is a number assigned by
the software.
100,001
1500
Layer 3 ports and some software features require internal
VLANs. Internal VLANs are allocated from 1006 and
up. You cannot use a VLAN that has been allocated for
such use. To display the VLANs used internally, enter the
show vlan internal usage command.
Switches running the Catalyst operating system do not
support configuration of VLANs 1006-1024. If you
configure VLANs 1006-1024, ensure that the VLANs do
not extend to any switches running Catalyst operating
system software.
You must enable the extended system ID to use extended
range VLANs.
Chapter 17 Configuring VLANs, VTP, and VMPS
Valid Values
1–4094
No range
1–4,294,967,294
1500–18,190
Propagated
by VTP
Yes
No