Resetting Portfast; Configuring Portfast Bpdu Guard; Enabling Portfast Bpdu Guard - Cisco WS-C2950SX-48-SI Configuration Manual

Catalyst 4500 series switches
Hide thumbs Also See for WS-C2950SX-48-SI:
Table of Contents

Advertisement

Chapter 8
Configuring Spanning Tree PortFast, BPDU Guard, BPDU Filter, UplinkFast, BackboneFast, and Loop Guard

Resetting PortFast

To reset PortFast on a switch or trunk port to its default settings, perform this task in privileged mode:
Task
Step 1
Reset PortFast to its default settings on a switch
port.
Step 2
Verify the PortFast setting.
This example shows how to reset PortFast to its default settings on port 1 of module 4:
Console> (enable) set spantree portfast 4/1 default
Spantree port
Console> (enable) show spantree portfast 4/1
Portfast:default
Portfast BPDU guard is disabled.
Portfast BPDU filter is disabled.
Console> (enable)

Configuring PortFast BPDU Guard

The following sections describe how to configure PortFast BPDU guard on the switch.

Enabling PortFast BPDU Guard

The PortFast feature is configured on an individual port, and the PortFast BPDU guard option is
configured either globally or on a per-port basis.
When you disable PortFast on a port, PortFast BPDU guard becomes inactive. The port configuration
overrides the global configuration unless the port configuration is set to default. If the port configuration
is set to default, the global configuration is checked. If the port configuration is enabled, the port
configuration is used and the global configuration is not used.
To enable and verify PortFast BPDU guard on a nontrunking switch port, perform this task in privileged
mode:
Task
Step 1
Enable BPDU guard on an individual port. set spantree portfast bpdu-guard mod/port [disable |
Step 2
Verify the PortFast BPDU guard setting.
For additional PVST+ information, see
Note
78-15486-01
4/1 fast start set to default.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Command
set spantree portfast mod_num/port_num
default
show spantree mod_num/port_num
Command
enable | default]
show spantree summary
Chapter 7, "Configuring Spanning Tree."
Configuring PortFast BPDU Guard
Release 8.1
8-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents