Configuring Authentication; Authentication Default Configuration - Cisco WS-C2950SX-48-SI Configuration Manual

Configuring Authentication

Figure 30-2 Non-Kerberized Telnet Connection
Configuring Authentication
The following sections describe how to configure the different authentication methods.

Authentication Default Configuration

Table 30-2
Table 30-2 Default Authentication Configuration
Feature
Login authentication (console and Telnet)
Local authentication (console and Telnet)
Local user authentication
TACACS+ login authentication (console and Telnet)
TACACS+ enable authentication (console and Telnet)
TACACS+ key
TACACS+ login attempts
TACACS+ server timeout
TACACS+ directed request
RADIUS login authentication (console and Telnet)
RADIUS enable authentication (console and Telnet)
RADIUS server IP address
RADIUS server UDP auth-port
RADIUS key
RADIUS server timeout
RADIUS server deadtime
RADIUS retransmit attempts
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
30-8
shows the default configuration for authentication.
Chapter 30 Configuring Switch Access Using AAA
Default
Enabled
Enabled
Disabled
Disabled
Disabled
None specified
3 times
5 sec
Disabled
Disabled
Disabled
None specified
Port 1812
None specified
5 sec
0 (servers not marked dead)
2 times
—
Release 8.1
78-15486-01