Configuring Local Authentication - Cisco WS-C2950SX-48-SI Configuration Manual

Configuring Authentication

Configuring Local Authentication

The following sections describe how to configure local authentication on the switch.
Enabling Local Authentication
Note Local login and enable authentication are enabled for both console and Telnet connections by default.
You do not need to perform these tasks unless you want to modify the default configuration or you have
disabled local authentication.
To enable local authentication on the switch, perform this task in privileged mode:
Task
Step 1 Enable local login authentication on the switch. Enter
the console or telnet keywords to enable local
authentication only for console or Telnet connection
attempts.
Step 2 Enable local enable authentication on the switch.
Enter the console or telnet keywords to enable local
authentication only for console or Telnet connection
attempts.
Step 3 Verify the local authentication configuration.
This example shows how to enable local login and enable authentication for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authentication login local enable
local login authentication set to enable for console and telnet session.
Console> (enable) set authentication enable local enable
local enable authentication set to enable for console and telnet session.
Console> (enable) show authentication
Login Authentication:
---------------------
tacacs
radius
kerberos
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
kerberos
local
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
30-12
Console Session Telnet Session
---------------- ----------------
disabled disabled
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Telnet Session
disabled disabled
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Chapter 30 Configuring Switch Access Using AAA
Command
set authentication login local enable [all |
console | http | telnet]
set authentication enable local enable [all |
console | http | telnet]
show authentication
—
Release 8.1
78-15486-01