Disabling The Daylight Saving Time Adjustment; Clearing The Time Zone; Clearing Ntp Servers - Cisco WS-C2950SX-48-SI Configuration Manual

Chapter 39 Configuring NTP
Offset: 1440 minutes (1 day)
Recurring: no
Console> (enable)

Disabling the Daylight Saving Time Adjustment

To disable the daylight saving time clock adjustment, perform this task in privileged mode:
Task
Step 1
Disable the daylight saving time clock adjustment.
Step 2
Verify the configuration.
This example shows how to disable the daylight saving time adjustment:
Console> (enable) set summertime disable Arizona
Summertime is disabled and set to 'Arizona'
Console> (enable)

Clearing the Time Zone

To clear the time zone settings and return the time zone to UTC, perform this task in privileged mode:
Task
Clear the time zone settings.
This example shows how to clear the time zone settings:
Console> (enable) clear timezone
Timezone name and offset cleared
Console> (enable)

Clearing NTP Servers

To clear an NTP server address from the NTP servers table on the switch, perform this task in privileged
mode:
Task
Step 1
Clear an NTP server address from the NTP server
table.
Step 2
Verify the NTP configuration.
This example shows how to clear an NTP server address from the NTP server table:
Console> (enable) clear ntp server 172.16.64.10
NTP server 172.16.64.10 removed.
Console> (enable)
78-15486-01
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Configuring NTP on the Switch
Command
set summertime disable [zone_name]
show summertime
Command
clear timezone
Command
clear ntp server [ip_addr | all]
show ntp [noalias]
—
Release 8.1
39-7