Running And Viewing Switch Topn Reports - Cisco WS-C2950SX-48-SI Configuration Manual

Chapter 22 Using Switch TopN Reports

Running and Viewing Switch TopN Reports

To run a Switch TopN Report in the background and view the results, perform this task in privileged
mode:
Task
Step 1
Run the Switch TopN Reports utility in the
background.
Step 2
View the generated report when it is complete.
You must enter the background keyword to the Switch TopN Reports utility to use the show top report
Note
command to view the completed report contents. Otherwise, the report is displayed immediately upon
completion of the process, and the results are not saved.
If you specify the report_num variable with the show top report command, the associated Switch TopN
report is displayed. Each process is associated with a unique report number.
If you do not specify the report_num variable, all active Switch TopN processes and all available Switch
TopN reports for the switch are displayed. All Switch TopN processes (both with and without the
background option) are shown in the list.
This example shows how to run the Switch TopN Reports utility with the background option:
Console> (enable) show top 5 pkts background
Console> (enable) 06/16/1998,17:21:08:MGMT-5:TopN report 4 started by Console//.
Console> (enable) 06/16/1998,17:21:39:MGMT-5:TopN report 4 available.
Console> (enable) show top report 4
Start Time:
End Time:
PortType:
Metric:
Port
----- ----- --- -------------------- ---------- ---------- ---------- ----- ----
1/1
2/1
1/2
2/10
2/9
Console> (enable)
To run the Switch TopN Reports utility in the foreground and view the results immediately, perform this
task in privileged mode:
Task
Run the Switch TopN Reports utility in the
foreground.
This example shows how to run the Switch TopN Reports utility in the foreground:
Console> (enable) show top 5 pkts
Start Time:
End Time:
78-15486-01
06/16/1998,17:21:08
06/16/1998,17:21:39
all
pkts (Tx + Rx)
Band- Uti Bytes
width % (Tx + Rx)
100 0
100 0
100 0
100 0
100 0
06/16/1998,17:26:38
06/16/1998,17:27:09
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Command
show top [N] [metric] [interval interval]
[port_type] background
show top report [report_num]
Pkts Bcst
(Tx + Rx) (Tx + Rx)
7950 81
2244 29
1548 12
0 0
0 0
Command
show top [N] [metric] [interval interval]
[port_type]
Running and Viewing Switch TopN Reports
Mcst Error Over
(Tx + Rx) (Rx) flow
0 81 0 0
0 23 0 0
0 12 0 0
0 0 0 0
0 0 0 0
—
Release 8.1
22-3