Cisco WS-C2950SX-48-SI Configuration Manual page 489

Chapter 30 Configuring Switch Access Using AAA
config:
all:
Console:
--------
exec:
enable:
commands:
config:
all:
Console> (enable)
Disabling TACACS+ Authorization
To disable TACACS+ authorization on the switch, perform this task in privileged mode:
Task
Step 1
Disable authorization for normal mode. Enter the
console or telnet keywords if you want to disable
authorization only for console port or Telnet
connection attempts. Enter the both keyword to
enable authorization for both console port and
Telnet connection attempts.
Step 2 Disable authorization for enable mode. Enter the
console or telnet keywords if you want to disable
authorization only for console port or Telnet
connection attempts. Enter the both keyword to
enable authorization for both console port and
Telnet connection attempts.
Step 3
Disable authorization of configuration
commands. Enter the console or telnet keywords
if you want to disable authorization only for
console port or Telnet connection attempts. Enter
the both keyword to enable authorization for both
console port and Telnet connection attempts.
Step 4 Verify the TACACS+ authorization configuration. show authorization
This example shows how to disable TACACS+ EXEC mode authorization for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authorization exec disable both
Successfully disabled enable authorization.
Console> (enable)
This example shows how to disable TACACS+ enable mode authorization for both console and Telnet
connections and how to verify the configuration:
Console> (enable) set authorization enable disable both
Successfully disabled enable authorization.
Console> (enable)
78-15486-01
tacacs+ deny
- -
Primary Fallback
------- --------
tacacs+ deny
tacacs+ deny
tacacs+ deny
- -
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
Command
set authorization exec disable [console | telnet |
both]
set authorization enable disable [console |
telnet | both]
set authorization commands disable [console |
telnet | both]
Configuring Authorization
—
Release 8.1
30-45