Setting Ethernet And Fast Ethernet Port Priority Levels; Setting Ethernet And Fast Ethernet Port Speeds - Cisco WS-C2950SX-48-SI Configuration Manual

Configuring Ethernet and Fast Ethernet Ports
This example shows how to set the name for ports 1/1 and 1/2 and how to verify that the port names are
configured correctly:
Console> (enable) set port name 1/1 Router Connection
Port 1/1 name set.
Console> (enable) set port name 1/2 Server Link
Port 1/2 name set.
Console> (enable) show port 1
Port
----- ------------------ ---------- ---------- ------ ------ ----- ------------
1/1
1/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Tue Jun 16 1998, 16:25:57
Console> (enable)

Setting Ethernet and Fast Ethernet Port Priority Levels

You can configure the priority level of each port. When ports request access to the switching bus
simultaneously, the switch uses port priority level to determine the order in which to give ports access.
To set the port priority level, perform this task in privileged mode:
Task
Step 1
Configure the priority level for a port.
Step 2
Verify that the port priority level is configured
correctly.
This example shows how to set the port priority level to high for port 1/1 and verify that the port priority
is configured correctly:
Console> (enable) set port level 1/1 high
Port 1/1 level set to high.
Console> (enable) show port 1
Port
----- ------------------ ---------- ---------- ------ ------ ----- ------------
1/1
1/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Tue Jun 16 1998, 16:25:57
Console> (enable)

Setting Ethernet and Fast Ethernet Port Speeds

You can configure the port speed on 10/100-Mbps Fast Ethernet modules. Use the auto keyword to have
the port autonegotiate speed and duplex mode with the neighboring port.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
4-4
Name Status
Router Connection connected
Server Link connected
Name Status
Router Connection connected
Server Link connected
Chapter 4 Configuring Ethernet and Fast Ethernet Switching
Vlan Level Duplex Speed Type
trunk normal half
trunk normal half
Command
set port level mod_num/port_num
{normal | high}
show port [mod_num [/port_num]]
Vlan Level Duplex Speed Type
trunk high half
trunk normal half
—
Release 8.1
100 100BaseTX
100 100BaseTX
100 100BaseTX
100 100BaseTX
78-15486-01