Compliance With Ec Directives - Omron SYSMAC CQM1-ID212 Operation Manual

Wiring and Connections

2-5-5 Compliance with EC Directives

1, 2, 3...
Requirement
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2. The relationship between the PC's ON current and the sensor's control out-
put (load current) must be as follows:
(min.) x I x I
I
OUT ON
Where, I = (V – V
ON CC
If I is less than I
ON OUT
constant of the bleeder resistor can be calculated as follows:
R x (V
– V )/(I
CC R OUT
Power W y (V
– V
CC
3. The relationship between the PC's OFF current and the sensor's residual
current must be as follows:
y I
I
OFF leak
Refer to Leakage Current (24 VDC) earlier in this section for details.
The value of I is different for different Units, and is 1.3 mA for all Units for
OFF
which the OFF current is not listed in the Unit specifications.
2-wire sensor
V : Power supply voltage
CC
V : PC's ON voltage
ON
I : PC's ON current
ON
I : PC's OFF current
OFF
R : PC's input impedance
IN
The following precautions must be abided by when installing CQM1-series PCs
to meet EC Directives.
1. CQM1-series PCs are classified as open-structure devices and must be
installed inside a control panel.
2. Use reinforced insulation or double insulation on the DC power supply con-
nected to DC Power Supply Unit and DC I/O Units.
3. CQM1-series PCs that meet EC Directives meet the common emission
standard (EN50081-2) of the EMC Directives as individual products. When
assembled into machinery, however, the noise generated by switching relay
outputs can fail to meet the standard. When noise is excessive, surge killers
must be installed or other measures must be taken outside of the PC. The
measures required to meet the standard will vary with the load being driven,
wiring, the configuration of the machinery, etc.
The following examples show means of reducing noise. These means will
only reduce the amount of noise and will not eliminate noise. They are pro-
vided here as examples only.
The following conditions can be used to determine if measures to reduce noise
are necessary. Refer to the EN50081-2 Standard for details.
• If the loads of the devices into which the PC is built are switched less than 5
times a minute, then no measures need to be taken.
• If the loads of the devices into which the PC is built are switched 5 times or
more a minute, then measures need to be taken.
(max.)
OUT
– 1.5 (residual voltage in PC))/R
R
(min.), connect a bleeder resistor, R. The resistance
(min.) – I )
ON
2
) /R x 4 (tolerance)
R
V
R R
R
IN
V
CC
V : Sensor's output residual voltage
R
I : Sensor's control output (load current)
OUT
I : Sensor's leakage current
leak
R: Bleeder resistor
Section 2-5
IN
DC Input
Unit
31