Water And Treatment Menu; Water Level; Ph Control - PoolCop Evolution Installer And User Manual

P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
5.4 W T
ATER AND
Water level, pH and disinfection and other treatment settings.
W a t er L e ve l
Set water level control parameters. PoolCop can be configured to
automatically refill water level.
When measuring the water level, the last known value blinks on the
screen. No action will be taken until the level is refreshed (displayed
level value will stop blinking).
An update is performed every 15 minutes when the pump is stopped
and if pump is controlled by filtration cycles.
When using 24/24 modes, water level is checked every hour
Installed
With INSTALLED: YES the menu options display and alerts are activated.
Water Level Control Modes
With mode: READ, PoolCop will indicate the water level on the screen but will not
take any action to control it. Should the level be
be displayed.
With mode: REFILL, if the level is below the setpoint, the refill system commands the
supply valve to open to refill the pool until the setpoint
detected. If the level is above setpoint, an alert will be displayed but the level will not
be reduced.
When using filtration cycles, if the pump starts during refill, the valve will close, and
refilling will be postponed until the next pump
in which case pool refilling will continue with the pump running.
With mode: REDUCE, level will be automatically reduced if above setpoint
V_HIGH) . If the level is below setpoint, an alert will be displayed but pool will not be
refilled.
With mode: AUTO, control combines
When using 24/24 mode, water level is checked every hour. Refill may start
immediately but will be paused after 30 min, to allow for treatment, and will then
continue after completed.
P a g e | 8 2
M
REATMENT ENU
When using filtration cycles ensure at least 30 minutes between cycles.
When using
LOW
OFF
REFILL and REDUCE
W A T E R A N D T R E A T M E N T
> Water Level Control
> Installed
S E L E C T
NOTE:
24/24 modes, water level is checked every hour.
or above setpoint, an alert will
(NORMAL or HIGH) is
period unless CONT. REFILL:
(HIGH
functionalities

pH Control

ORP Control
Remnant Injection
ACO Injection
Free Available CL
S E L E C T
W A T E R L E V E L
: YES
Mode : REFILL
Setpoint : High
Cont. Refill : NO
Max Duration : 60 mn
Draining : 120 sec
Priming : OFF
Text:
Default:
Entries:
Text:
Default:
Entries:
YES,
or
Q U I T
Q U I T
Installed
NO
YES;
NO
Mode
Read
Read;
Refill;
Reduce;
Auto