PoolCop Evolution Installer And User Manual page 66

P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
Set and Adjust Filtration
PoolCop allows you to manually or automatically control the filtration duration. See Programming Guide for more information.
Whenever quitting the FILTRATION MODES
them ON or OFF as required to match programmed run times.
4.4.4.6.1 Filtration Timers and Modes
Navigate to FILTRATION MODES
Select the MODE.
Use the UP and DOWN arrows to adjust the ON and OFF times.
Use the SELECT button to enter the adjusted value.
Unless using 24/24 mode or
is recommended to leave a gap of at least 30 minutes between two timer cycles to allow PoolCop to take necessary measurements
make subsequent adjustments and carry out the periodic backwash if selected.
00 01 02 03 04
FIRST CYCLE
If, however the timers are set to overlap, then the total filtration time will be from the earlier cycle ON time until the later timer OFF
time.
00 01 02 03 04
FIRST CYCLE
It is recommended to never exceed 23:00 per day, to allow PoolCop to take necessary measurements, make subsequent adjustments
and carry out the periodic backwash if selected.
00 01 02 03 04
FIRST CYCLE
P a g e | 6 6
menu, PoolCop checks and adjust the status of the pump and auxiliaries and switches
in the POOLCOP MENU.
NO PUMP mode, it is recommended to set both filtration cycles (Cycle 1 and Cycle 2) for best results. It
05 06 07 08 09
05 06 07 08 09
05 06 07 08 09
10 11 12 13 14
SECOND CYCLE
10 11 12 13 14
SECOND CYCLE
10 11 12 13 14
SECOND CYCLE
15 16 17 18 19
15 16 17 18 19
15 16 17 18 19
21 22 23 00
21 22 23 00
21 22 23 00