PoolCop Evolution Installer And User Manual page 15

P o o l W i n t er i za t i o n
Active Winterization
Maintaining the pool year-round avoids chemical shock treatment, the use of expensive treatment and cleaning products, and much
labor. Suggested Settings:
Commercial Pools, required filtration modes are:
24/24 if the pump start/stop is controlled by the pump relay.
•
See 5.2 Filtration Mode Menu if the pump is controlled by the pump relay for other modes.
•
Residential Pools, recommended modes are:
See 5.2 Filtration Mode Menu if the pump is controlled by the pump relay for suitable modes.
•
Set freezing mode protection ON in the Pool Data menu.
Filtration will run at any time should a freezing risk be detected based on water and air temperatures (as installed).
•
for details and settings.
•
pH regulation will continue to function normally at all temperatures.
Disinfection is stopped below the Disinfection Minimum Temperature as set in the Configuration/Maintenance menu.
Passive Winterization
Get the advice of a pool qualified installer on the best solution in the area and with the type of pool.
It is recommended that the equipment remains ON and electricity supply connected to keep internal circuits warm and dry.
Suggested Settings:
The pump and all accessories (pool cleaner pump, heat pump, etc.) should be switched OFF at the appropriate circuit breaker.
Select the filtration mode STOP.
Purge the water circuit.
Ensure that the water level control is stopped (Configuration/Water Level; the mode must be "Read Only").
Purge the refill circuit.
Remove the pH+ORP sensor and store in a location away from risk of freezing; use the sensor transport cap supplied or
suitable container and ensure the end of the sensor remains moist.
Remove the sensor holder and seal with the original plug.
R e - C o m m i s s i o n in g t h e E q u i p me n t
When re-opening the pool after passive winterization (or out or service for a period of time) carry out the following procedure:
Replace the pH+ORP sensor if removed.
Perform an annual service (see 2.3.2.2).
Continue with the normal maintenance cycles of the pool and the equipment.
Active Winterization is not possible with all installations or in all areas,
and less desirable in very cold areas where solid freezing is a bigger risk.
Passive Winterizing is not possible with all installations or in all areas.
P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
CAUTION
CAUTION
P a g e | 1 5