P a g e | 7 4
5.4
Water and Treatment Menu
W
L
A T E R
E V E L
Set
water
level
control
parameters. PoolCop can be
configured to automatically
refill and reduce water level.
When PoolCop is updating the water level, the last known value blinks on the screen. No action will be taken as long as the new
level is not refreshed (displayed level value will stop blinking). An update is performed every 15minutes when the pump is
stopped.
Make sure to keep at least 30 minutes between filtration cycles to allow water level to function properly.
5.4.1.1 Installed
With
INSTALLED:
YES, the menu options display and Alerts are activated.
5.4.1.2 Water level Control Modes
Water level is updated every 15 minutes when the filtration is stopped.
With mode: READ, PoolCop will indicate the water level on the screen but will not
take any action to control it. Should the level be
displayed.
With mode: REFILL, if the level is
open to refill the pool until the
will be displayed but the level will not be reduced.
If the pump starts during refill, the valve will close and refilling will be postponed until
the next pump
OFF
period unless
continue with the pump running.
With mode: REDUCE, level will be automatically reduced if V_HIGH. If the level is
LOW, an alert will be displayed but pool will not be refilled.
With mode: AUTO, control combines
5.4.1.3 Continuous Refill
This setting is displayed if mode:
To avoid pool water flowing back in the water supply circuit, pool refill is normally
inhibited when the pump is running. During pool refill if the pump is started manually
or with a timer or mode, pool refill is suspended until pump is stopped again. With
CONT. REFILL: OFF
water refill stops whenever the pump starts.
In some installations (such as with low flow rate filtration) pump running time does
not allow enough free time to adequately refill the pool. In such cases,
allows refilling whilst the pump is running. With
refill will continue until the water level is HIGH, even if the pumps starts.
With
REFILL CONT:
the water supply. This poses a health risk and may only be used if the house water supply is separate from
www.poolcop.com
W A T E R L E V E L
Installed
Mode
Cont. Refill
Max Duration
Draining
S E L E C T
LOW
or
LOW
the refill system commands the supply valve to
HIGH
level is detected. If the level is V_HIGH, an alert
CONT. REFILL:
YES, in which case pool refilling will
REFILL
and
REDUCE
REFILL
or FULL.
CONT. REFILL:
YES, a poor installation or a defective non-return valve could allow pool water to enter
Technical Support "Hotline" +33 (0)4 90 09 54 26
: YES
: AUTO
: NO
: 60 mn
:120 sec
Q U I T
NOTE:
V_HIGH,
an alert will be
functionalities
CONT. REFILL
YES, once started the
WARNING:
the pool water supply.
P o o l C o p M a n u a l : V 3 1 E N
Default:
NO
Entries:
YES;
NO
Default:
Rea
Entries:
Read;
Refill;
Reduce;
Auto
Default:
NO
Entries:
YES;
NO
PCFR
Need help?
Do you have a question about the PoolCop and is the answer not in the manual?
Questions and answers