Equipment Control (Requires Xm8 Extension Module) - PoolCop Evolution Installer And User Manual

P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
you will be prompted to start the pump (unless Filtration Mode is not set for "NO PUMP")
If auxiliary is slaved, the pump must be primed before switching
the Aux to ON. Pump will be declared primed when pump is ON,
pressure is above the protection pressure setting and flow is
detected at the flow switch (if installed).
To start the pump, press
pump command page, otherwise press
E q u i p me n t C o n t r o l ( r e qu i r e s X M8 e x ten s i on m o d u l e )
Equipment are specific devices such as Pool Cover, JetStream.
Navigate to MANUAL
Scroll UP or DOWN to place cursor at
Press SELECT.
Scroll UP or DOWN to select the equipment you want to control
(depending on the actual configuration)
Pool Cover (requires XM8 extension module)
Scroll UP or DOWN to select the action to be executed.
Press SELECT to launch the command.
When both commands are OFF, the motor is stopped.
Actual cover position is shown.
P a g e | 7 0
If the Auxiliary is slaved to filtration and the pump is not ON or not primed,
PUMP button to jump to the
QUIT.
CONTROL.
EQUIPMENT.
NOTE:
A U X I L I A R Y
Aux cannot run if
Pressure is lower
Start the pump?
P U M P
M A N U A L
Pump
Auxiliaries
Check Level
Clean Filter
Valve Rotation
> Equipment
S E L E C T
E Q U I P M E N T
Pool cover
>
JetStream
S E L E C T
P O O L
> Command Open:
Command Close:
Position: CLOSED
S E L E C T
S L A V E D
than
0.2 Bar
Q U I T
C O N T R O L
Q U I T
Q U I T
C O V E R
OFF
OFF
Q U I T