PoolCop Evolution Installer And User Manual page 109

JetStream
Set JetStream parameters.
5.6.6.2.1 Installed
If INSTALLED: YES, PoolCop will be able to control a JetStream via the push button in
the pool or via a direct command.
If set to NO, the JetStream (if any) will be operated manually.
5.6.6.2.2 Setting Command (Aux13 Settings)
When JetStream is installed,
preconfigured in pulse mode with 60 minutes pulse duration. These
settings can be changed from this view.
If the pool has a cover and the cover is detected closed by PoolCop, then the JetStream pump is forced
OFF for safety reasons. JetStream pump is only allowed to run when the cover is not closed.
5.6.6.2.3 Setting Push Button (In9 Settings)
When JetStream is installed, In(9) is preconfigured to receive the push
button action. The settings can be changed from this view.
The push button pneumatic signal must be converted into an electrical contact outside PoolCop using a
P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
Aux13 (Pump command)
pressure switch. The contact will be then connected on In(9).
J E T S T R E A M
> Installed
Setting Command
Setting Pushbutton
S E L E C T
Text:
Default:
Entries:
A U X 1 3 : R s r v ' d J e t S t
> Mode
ON
is
Duration
Slave
Weekday
S E L E C T
NOTE:
I N P U T 0 9
> JetStream
Action when
Alert
S E L E C T
NOTE:
: YES
Q U I T
Installed
NO
YES;
NO
: Pulse
: 00:00
: 00:60:00
: NO
✓✓✓✓✓✓✓
:
Q U I T
: Closed
: NO
Q U I T
P a g e | 1 0 9