Using And Settings; Illuminate The Backlight; Navigate The Menu; Return To Main Display - PoolCop Evolution Installer And User Manual

4.4 U S
SING AND ETTINGS
I l l u m i n a t e t he B a c kl i g h t
Pressing any button illuminates the backlight.
The backlight remains on for 3 minutes.
Note:
Water temperature and air temperature are shown alternatively on the same row.
An Up or Down blinking arrow may appear on the right of pH value: this will be the case if:
pH is controlled by PoolCop (pH control is installed, and pH type is pH+ or pH-).
•
Up arrow: pH value is more than 0.1 above setpoint.
•
Down arrow: pH value is more than 0.1 below setpoint.
•
An Up or Down blinking arrow may appear on the right of ORP value: this will be the case if:
ORP is controlled by PoolCop (ORP control is installed and ORP type is different from "Read").
•
Up arrow: ORP value is more than 50mV above setpoint.
•
Down arrow: ORP value is more than 50mV below setpoint.
•
N a v i g a t e t h e Me n u
Press the MENU
POOLCOP MENU is displayed.
Use the UP and DOWN buttons to choose the submenu
(in this case Manual Control), then press
to that submenu.
Repeatedly pressing
R e t u r n t o M a in D i s p l a y
When viewing any menu screen:
Press QUIT to go up one menu level.
Every display has a 15 second timeout to go back to the
previous menu. The display will timeout to the main
display within approximately 1 minute.
button.
SELECT
QUIT to return to the main display.
P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
1 2 : 4 6 : 0 1
Valve
Pump STOP
Water Temp
Level
pH
ORP
M E N U
P O O L C O P
> Manual Control
Filtration Modes
Auxiliaries
Water and Treatment
to go
Maintenance
Configuration
S E L E C T
P O O L C O P
> Manual Control
Filtration Modes
Auxiliaries
Water and Treatment
Maintenance
Configuration
S E L E C T
0 1 / 0 6 / 2 0 1 4
: Filter
: 0.00 Bar
: 28 °C
: Normal
: 7.2
: 690mV
M E N U
Q U I T
M E N U
Q U I T
P a g e | 5 9