Maintenance; Service Mode; Pressure Inhibition; Measure Ph - PoolCop Evolution Installer And User Manual

5.5 M
AINTENANCE
Specific parameters dedicated to pool maintainers.
S er v i c e M o de
In service mode, PoolCop stops all its automatic actions. Every connected device
(pump, Auxiliaries, water refill...) is stopped when using this mode.
PoolCop will only respond to manual command.
This mode could be used for passive winterization or during maintenance actions.
P r e s s u r e in h i b i t i o n
In the event of a pressure sensor failure, actions related to pressure measurement can
be inhibited. This is only possible if a flow switch has been configured (see 5.6.4.1
Digital Inputs).
Chemical injections security will be based solely on the flow switch signal, so make sure the flow switch
M e a s u r e pH
Perform an extra pH measurement.
The filtration pump must be stopped to allow measurement (except
in 24/24 mode)
P o o l C o p E v o l u t i o n M a n u a l : E V 4 4 M A N U S
When pressure is inhibited, valve rotation is no longer possible.
This also locks filter cleaning.
is working properly.
M A I N T E N A N C E
> Service Mode
Press Inhibit

Measure pH

Calibrate pH
Value FAC
Calibrate FAC
Calibrate Conduct
Salt Level
Air AntiFrz.
Stop treatmnt
Calib T° (=)
S E L E C T
Text:
Default:
Entries:
Text:
Default:
Entries:
CAUTION:
p H R E A D I N G
Check TAC >80 ppm
Last pH reading:
20:12 15-03-2020
S E L E C T
: NO
: NO
: 7.7
: 0.1
: 3.2
: 1.2
: 200uS
: 2.5
: 5°C
: 12°C
: 28°C
Q U I T

Service Mode

NO
YES;
NO
Press Inhibit
NO
YES;
NO
Press SELECT
Q U I T
P a g e | 9 1