• Avoid entering the Hibernation Mode while a communication operation
is in progress, or while a peripheral (disk, printer, etc.) is in use.
Entering the Hibernation Mode while a communication operation is in
progress will cause a communication error on the other computer.
• You can reset FIVA and force power to turn off by holding down the
power switch for 4 seconds. Note that FIVA does not beep if sound
output is muted. Use this method to reset FIVA only when operation
locks up and nothing else works.
To enter the Standby Mode and Hibernation Mode by closing
the display panel
FIVA automatically enters the Standby Mode whenever you close the
display panel. Reopening the display panel restores the Windows Me
screen that was displayed when you closed it.
If you leave the display panel closed for longer than about ten minutes,
FIVA automatically switches from the Standby Mode to the Hibernation
Mode. To recover from the Hibernation Mode, open the display panel
and slide the power switch. The Windows Me screen that was displayed
when you initially closed the display panel reappears, but it will take
more time than that of recovery from the Standby Mode.