Chapter 9
Creating an IP Interface
Creating an IP
Interface Using
the Web Agent
9-2
The following sections explain how to enable IP routing and assign
subnets.
When you create an IP interface, you activate a location in the
switch that communicates between IP and the embedded software
of the switch.
You can create an I{P interface using either the web agent or the
CLI.
To create an IP interface using the web agent:
1. Select Interfaces from the Routing > IP > Configuration group
on the web agent window. The IP Interfaces dialog box opens
(Figure 9-2).
* Note: Due to the length of the IP Interfaces dialog box,
it is shown as two figures in Figure 9-1.
Figure 9-1. IP Interfaces Dialog Box
Cajun P550/P880/P882 Switch User Guide