Creating a Static
Multicast
Session Using
the CLI
Cajun P550/P880/P882 Switch User Guide
Figure 16-6. Static Multicast Session Configuration Dialog Box
3. Configure the Static Multicast Session Configuration dialog
box parameters (refer to Table 16-6):
Table 16-6. Static Multicast Session Configuration Dialog Box
Parameter
Definition
IP Address
Enter the IP address of the new static multicast
session. The range must be between 224.0.1.0 to
239.255.255.255.
MAC Address
Enter the MAC address of the new static multicast
session. Specifying the MAC address is not used for an
IP multicast session.
VLAN
Enter the VLAN associated with the new multicast
session. Click All to add all VLANs to the multicast
session, or select a specific VLAN from the pull-down
menu.
4. Click CREATE to create the new static multicast session, or
CANCEL to restore previous settings.
To create a new static multicast session using the CLI, enter the
following command from Configure mode:
cajun(configure)# set intelligent-multicast
session <group-address|mac-address>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
Managing Intelligent Multicasting
Parameters
16-15