Creating An Ip Routed Interface On The Vlan - Avaya P550R User Manual

Creating an IP
Routed
Interface on the
VLAN
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink User Guide, Version 2.0.
* Note: You cannot edit the Mirror Port field.
h. Click Apply to save your changes, or Cancel to restore
previous settings.
8. To create an IP Routed interface on the VLAN:
* Note: Refer to "Creating an IP Interface" in Chapter 9,
"Configuring IP Routing" in the Avaya P550R/
P580/P880/P882 Multiservice Switch User Guide for
more information.
a. Select Routing > IP > Configuration > Interfaces from
the Web Agent. The IP Interfaces dialog box opens.
b. Select CREATE from the bottom of the IP Interfaces dialog
box. The Add IP Interface dialog box opens.
c. Refer to Table 89
d. Click CREATE to save your changes, or CANCEL to
restore previous settings.
Table 89. Add IP Interface Dialog Box Parameters
Parameter Definition
Interface Enter a unique, alphanumeric name for the
interface.
If you do not enter a name for the interface, the
system uses the IP address.
Interface Type Options include:
Note:
Note:
Admin. State Specify the administrative state of the interface.
Options include:
to configure the IP interface.
• EthernetLAN - Standard interface type for
a Broadcast environment such as Ethernet.
• NBMA - Non-Broadcast Multi-Access for
networks that do not have built in broadcast
capabilities yet allow multiple hosts to
connect, such as ATM.
Each IP interface on a network segment
must have the same Interface type.
Type must be set to NBMA if using a
Routed VSP.
• UP - The interface is active.
• DOWN - The interface is inactive.
Configuring RFC 1483
4-45