Chapter 3
Setting the
Temperature
System Using
the CLI
Displaying the Power System Statistics
Displaying the
Power System
Statistics Using
the Web Agent
3-14
2. Enter your desired temperature warnings in the slot 1 Sensor,
and the Backplane Sensor fields.
* Note: If your switch is a layer 3 switch, you must also
enter a temperature warning in the CPU Sensor
field.
3. Click APPLY to save your changes, or CANCEL to clear your
selection.
To configure the temperature warning systems using the CLI, enter
the following command from Configure mode:
cajun>(configure)# set temperature <backplane-
sensor> <cpu-sensor> <probe>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
You can display the statistics for your switch's power system from
the either the web agent and the CLI.
To display your switch's power system statistics using the Web
Agent:
1. Select Power System from the System>Configuration group
on the web agent window. The Power System dialog box
opens with your switch's current power statistics. (Figure 3-
8.
Cajun P550/P880/P882 Switch User Guide