Modifying Ospf Interfaces; Modifying Ospf Interfaces Using The Web Agent; Ospf Interfaces Dialog Box - Avaya Cajun P550R User Manual

Modifying OSPF Interfaces

Modifying OSPF
Interfaces Using
the Web Agent
Cajun P550/P880/P882 Switch User Guide
You can modify the parameters on an OSPF interface using either
the web agent or the CLI.
To modify an OSPF interface using the web agent:
1. Select Interfaces from the Routing > IP > OSPF group in the
web agent window. The OSPF Interfaces dialog box opens
(Figure 11-4).
Note: You must first enable OSPF before you can modify
OSPF interfaces. Refer to Configuring a Static
Route for the PPP Console in Chapter 9 for
information on how to enable OSPF on IP
interfaces.
Figure 11-4. OSPF Interfaces Dialog Box
2. Modify the OSPF Interfaces dialog box parameters. Refer to
Table 11-3 for an explanation of these parameters:
Table 11-3. OSPF Interface Dialog Box Parameters
Parameter Definition
Select Select the OSPF interface to be modified.
Interface
Displays IP interface (VLAN) that has OSPF enabled.
Note:
IP Address Displays IP address associated with the OSPF interface.
Note:
Area
Enter the area ID configured for this interface.
DR Priority
Enter the decimal value for this interface for DR
priority functionality.
Transit Delay
Enter the estimated time (seconds) it takes to transmit
a link state update packet over this interface.
Configuring the OSPF Routing Protocol
This is a read-only field.
This is a read-only field.
11-7