Enabling The Lgmp Server Using The Cli; Configuring The Lgmp Server; Configuring The Lgmp Server Using The Web Agent - Avaya Cajun P550R User Manual
Avaya p550r: user guide
Hide thumbs
Also See for Cajun P550R:
- Cli reference manual (617 pages) ,
- User manual (174 pages) ,
- Installation manual (62 pages)
Table of Contents
Advertisement
Enabling the
LGMP Server
Using the CLI
Configuring the LGMP Server
Configuring the
LGMP Server
Using the Web
Agent
Cajun P550/P880/P882 Switch User Guide
2. Select Enable from the State field, if it is not already
displayed.
3. Click Apply to complete the operation or Cancel to ignore the
operation.
To enable the LGMP server using the CLI, enter the following
command from Configure mode:
cajun(configure)# set lgmp server enable
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
You can configure the LGMP server using either the web agent or
the CLI.
To configure the LGMP server using the web agent:
1. Select LGMP Snooping from the L2 > Intelligent Multicast
group on the web agent window. The LGMP Server
Configuration dialog box opens (Figure 16-9).
*Note: You must enable intelligent multicasting on a
global basis to activate the LGMP Server. LGMP
serving is only active on VLANs with an IGMP
interface enabled and IGMP snooping globally
enabled.
2. Refer to Table 16-9 to configure the LGMP Server
Configuration dialog box parameters:
Table 16-9. LGMP Server Configuration Dialog Box Parameters
Parameter
Enable State
Proxy Mode
Managing Intelligent Multicasting
Definition
Select to enable or disable LGMP server
configuration. The default value is Disabled.
Select to enable or disable Proxy mode. Proxy
mode allows the server to send LGMP router
report and leave messages on behalf of neighbor
routers on the same VLAN.
16-23
Advertisement
Table of Contents
